Electrical inline duct heater Inline Duct heater with spigot connection for standard spiral ducts. Manufactured from Aluzinc-coated sheet steel with a heating element in stainless steel. The duct heater has integral overheating protection with a manual reset function. The duct heater has rubber seals on the connecting spigots. Suitable for control...
Electrical inline duct heater
Inline Duct heater with spigot connection for standard spiral ducts. Manufactured from Aluzinc-coated sheet steel with a heating element in stainless steel. The duct heater has integral overheating protection with a manual reset function. The duct heater has rubber seals on the connecting spigots. Suitable for control by room thermostat or Pulser. The minimum air volume is based on a minimum air velocity of 1.5 m/s. These inline duct heaters are designed for a maximum output air temperature of 50°C. The ductwork heater units can be installed in a horizontal or vertical duct. In horizontal ductwork, the connection box should be installed facing upwards or rotated 90° to one side. Installation with the connection box facing downwards is not allowed.
Made to order | Yes |
Product Category | Duct Heaters |
Round System (mm) | 315 |
Product Type | Duct Heater |
Product Group | Metal Ducting |
Product Variety | 9000W 400V 3 Phase |
Economy Delivery | Not Eligible |
Next Day Delivery | Not Eligible |
Quick Search: | QS9725 |
Your question will be sent to a member of our team. We'll email you the answer and post it on this page. If your question is about an order you already placed, please use our Contact Form to reach the customer service team.
Good Afternoon, Please can you email across the technical information for this product at your earliest convenience, and importantly the product dimensions? I cant seem to access the PDF's on the website. Many thanks for your help Kind regards Sonia
Hello Sonia
Hi there, what temperature increase could I expect from a heater this size if I was pulling 2,000CFM of air through it? Thank you!
Hello Wes
What duct fan would you recommend for this duct heater. I have a 22mtr x 12 mtr garage to heat would these be suitable and would three independantly controlled units ba sufficient. Is there a minimum/maximum length of duct?
Hi David.
Hi, I have contacted you before hopefully i can now give you more info. I have an area to heat, i want to use the heater above (there will be three independant) i want three phase to try and balance the load more effectively. Basically i want to mount the heater in a duct (near the output end) and then mount the fan further back, can you advise on which fan i should use, does there have to be an interlock between the fan and the heater in case the fan fails? can i use a standard room stat via a contactor for control? What is the best output spigot to put on the end. Thankyou
Hello David
Customers who bought this product also purchased |