Rytons 9X3 Floor Vent Set - Brass

Rytons FV10BRASS – Rytons Floor Ventilator with Brass Louvre

Product Summary:

• Room ventilator utilising air from a ventilated sub-floor void.
• Mirror polished solid brass louvre grille provides a stylish appearance.
• Inverted louvres give a flush finish.
• Brass coloured screws included.
• BBA approved – your independent assurance that the product meets building regulations and standards and will last.

Free Area

• 11000mm² (110cm²) per set.

Size

267mm L x 95mm H x 125mm D.

See our image gallery above for a dimensional drawing. AutoCAD drawing available by email.

Colours

• Louvre Grille: Polished brass.
• Sleeve: Black.

Composition

• Louvre Grille: 1mm thick half hard solid brass.
• Sleeve: Polypropylene. Contains recycled plastic.
• Melting Point: Louvre Grille: Approximately 900°C.

Installation

1. Cut an opening in the floor and insert sleeve (sleeve can be trimmed with a fine-tooth saw to reduce the depth if required).
2. Fasten louvre through pre-formed holes in the flange around the sleeve using screws provided.
3. Peel off the protective film.
4. Note: When installing in an uncarpeted floor the flange may be trimmed back slightly and the louvre ventilator screwed into the floor to maintain as flush a finish as possible.
5. Important: In areas where radon gas has been identified as a problem, ventilation shall not be taken from the space below ground floor level (e.g. using a floor vent), or interfere in any way with any remedial measures already in place to prevent radon gas entering the habitable part of the dwelling.

UK Regulations and Standards

• The Building Regulations, Approved Document J.
• The Building (Scotland) Regulations, Mandatory Standard 3.21.
• The Building Regulations (Northern Ireland),
• Technical Booklet L. British Standard BS 5440-2:2009.
• For venting, decorative fuel effect gas fires refer to British Standard BS 5871-3:2005.

Handling Information

• Box quantity: 1 set.
• Box size: 28cm W x 11cm H x 14.5cm D.
• Box weight: 0.39kg.