• Easy to fit and use.
• For use where outside venting is not possible.
• Reduces damaging condensation.

This Kit enables you to use your tumble dryer without the need to vent externally. The unit is compatible with ALL makes and models of tumble dryer. Simply fill the container half-full with cold water and empty after use.

CONTENTS
A. Vent tub and lid.
B. Hose connector.
C. Flexible Hose.
D/E/F. Universal adapter.
G. hose fixing studs.

Fitting Instructions
1. Verify content of box.
2. Attach one end of the PVC hose to the universal adapter (D) using three studs (G) provided.
3. Screw other ends of the hose into the threaded hose connector (B).
4. Fix other end of the universal adapter (F) over tumble dryer outlet hole and fix in place with the self adhesive gasket (E).
5. Push universal adapter (D) into (F).
6. For best performance cover bottom of vent tub with ice cubes. Alternatively fill with cold water to a depth of 40mm.
7. Push threaded connector (B) into hole on lid.
8. Fix lid to base using fixing clips. Be sure not to kink the hose as this could restrict the air flow.

NOTE
During the course of operation, the water in the tank will fill with lint. Replace the water when needed. Always check the water level in the unit, as it will also collect excessive moisture from air, and spillage could occur if not checked regularly.

CAUTION
Not recommended for use with gas tumble dryers.
When using indoor tumble dryer kit, open a door for a adequate distribution of moisture and heat.
A tumble dryer should NEVER be used in a bathroom or in a confined space.