This clip can be used to connect 100mm Flexi / 4 inch flexible ducting to fittings and can be used as a part of a long ductwork run for a variety of purposes including whole-house ventilation, passive stack vent, air conditioning, HVAC, and Heat Recovery Systems.
Looking for compatible products?
Compatible with the extensive Kair SYS-100 range of fittings, outlets, and grilles.
|Alternative Product Code||DUCKVC264|
|Product Category||Hose Clips|
|Round System (mm)||100|
|Product Type||Hose Clip|
|Product Group||Plastic Ducting|
|Packaged Weight (Kg)||0.031|
|Packaged Length (mm)||10|
|Packaged Width (mm)||110|
|Packaged Height (mm)||120|
|Temp Max (°C)||60|
|Temp Min (°C)||-15|
|Barcode - Type||EAN|
Your question will be sent to a member of our team. We'll email you the answer and post it on this page. If your question is about an order you already placed, please use our Contact Form to reach the customer service team.
Would this be ok for securing 102mm flexible hose to the Aventa 100mm in line mixed flow fan ?
Yes this product would be suitable as the product adjusts from 90mm - 110mm.
However an alternative product is the QUICK RELEASE WORM DRIVE CLIPS - STEEL - 60-135MM (Product Code: "GALFIX-QRWC-60-135"). You may find this product a lot faster and easier to install.
Please let me know if I can offer any further advice.
Hi do I need this hose clip to fit rigid 100 round ducting.
Thank you for your question. No this clip is not required. The pipe is a female connection and the bends and spigot connections are male so the pipe will slip over the connections and you just seal with sealant and seal the joints with duct tape. If I can help any further please do not hesitate to contact me on 0208 463 9683.
|Customers who bought this product also purchased|
|Ducting System||Actual dimensions (mm)||Space requirements (mm)||Airflow mm²|
For 4" (100mm) extractor fans or for low power cooker hoods up to 250m³/hour
|System 100 - Round||100||106||7,854|
|System 100 - Rectangular||110 x 54||116 x 60||5,940|
For medium extraction rates or if available depth is limited up to 500m³/hour
|System 125 - Round||125||131||12,272|
|System 125 - Rectangular||150 x 70||156 x 76||10,500|
For 6" (150mm) extractor fans or for high power cooker hoods up to 500m³/hour & above
|Megaduct 220 - Rectangular||220 x 90||227 x 97||17,968|
|System 204 - Rectangular||204 x 60||210 x 66||12,240|
|System 150 - Round||150||156||17,671|
|System 150 - Rectangular||180 x 90||186 x 96||16,200|
For a shallow space, such as ceiling voids or under floor, where high extraction rates are not needed:
|System 300 - Rectangular||308 x 29||314 x 35||8,932|
|System 225 - Rectangular||234 x 29||240 x 35||6,786|
| System 100 |
| System 125|
| System 150|
|System 204||System 225|
|System 220||System 300|
|Actual Dimensions (mm) Space Requirements (mm)|