Vectaire AS10TPLUS As Plus Slimline 100mm Axial Fan With Timer

VECTAIRE AS PLUS SLIMLINE 100MM AXIAL FAN WITH TIMER

Summary:

• Slimline axial fans
• Can be ducted up to 6m
• White or Chromium
• 8 models
• Timer, Humidity Control and Passive Infra Red models
• IPX4 - Splashproof
• For toilets, shower-rooms and bathrooms
• For walls, ceilings or panels
• Fixed shutters
• Complies with Building Regulations Approved Document F (2006)

General:

• Axial fans to exhaust air and fumes directly outside or through ducting up to 6 metres in length
• Advanced aeraulic design for improved pressure characteristics
• AS10Plus fans will extract 20.3 litres/sec (73m3/hr) at a pressure of 20Pa
• Streamlined for improved air flow
• Indicator to show when operating
• Ultra slim profile for unobtrusive installation
• Incorporates backdraught shutter
• Innovative impeller design to guarantee low noise levels
• Adjustable timer - 3-25 minutes
• Dynamic humidistat with night time set back and anti-hunting device
• Wiring can be surface mounted or recessed
• IPX4 - Splashproof - Install in accordance with IEE Wiring Regulations

Specification:

• Casings from shockproof, high quality techno-polymer
• Double insulated motors of shaded pole type mounted on self-lubricating, sealed ball bearings for long life
• Energy efficient design
• Motors incorporate thermal cut-out
• Maximum ambient temperature - 40°C

Compliance:

1. EN60335-2-80
2. EC Low Voltage Directive 73/23-93/68
3. EC Directive EMC89/336
4. CE marked
5. Keymark Approved

Typical specification:

Supply and install an AS10TPlus axial fan with integral over-run timer (adjustable between 3 and 25 minutes) as supplied by Vectaire Ltd, Lincoln Road, Cressex Business Park, High Wycombe, Bucks, HP12 3RH. The fan is to be suitable for installation either into a ceiling, wall or panel (with the appropriate accessories), and have the capability of being ducted for up to 6m. There should be a neon on the front of the fan to indicate when it is operating. The fan casing should be made of shockproof, high quality technopolymer, contain a motor with sealed, self-lubricating bearings, and be protected with a thermal cut-out. The fan should be double insulated and be suitable for installation into Zones I and II. The fan is to be CE marked and comply with current EC Low Voltage Directive EMC89/336 and with BSEN60529. The fan should finally comply with Building Regulations requirements for installation into a toilet, bathroom or shower room.