Vectaire PPF9 Loft Mounted Positive Pressure Unit

VECTAIRE PPF9 LOFT MOUNTED POSITIVE PRESSURE UNIT

Product Description:

The unit is supplied complete with a ceiling diffuser, flexible duct, worm drive clips, plasterboard fixings and screws, and attenuation mounts.

General

• Positive pressure ventilation provides effective, draught free ventilation and prevents condensation forming
• Easy to install - the PPF9 can be used both in the refurbishment of older properties where condensation is a particular problem as well as in new build.
• The PPF9 introduces tempered air, drawn in through the loft, to create a positive pressure in the building.
• Tempered, filtered, fresh air enters the living areas from the fan, via a short length of flexible ducting, through a discreet ceiling mounted diffuser.
• The fresh air circulates throughout the building giving draught-free ventilation and eventually dissipating through openings around the property.
• The PPF9 runs continuously to provide a constant background air change and maintain a healthy and comfortable environment.
• Since the moisture content of the air outside is normally lower than that indoors, the level of humidity is reduced, helping to eliminate the damaging effects of condensation.
• A PPF9 provides extra security - there is no need to open windows.
• The noise levels are extremely low.
• The system is very economical and can cost less than £5 per year to run.
• 2 year warranty - 1 year parts and labour, 1 year parts only

Specification

• For small, medium or large domestic properties
• Easy loft installation
• Choice 3 speed levels (set at installation)
• Robust construction - fan casing is an integral, one piece unit with a filter box attached.
• Air inlet is provided on all sides of the unit
• Incorporates a specially developed fan/motor assembly
• Motor mounted on sealed, self-lubricating bearings
• Protected with thermal cut-out
• Double insulated
• Maximum ambient temperature 40ºC
• Complete with ceiling diffuser, flexible duct, worm drive clips, plasterboard fixings and screws and attenutation mounts
• Easy to maintain - motor and fan blades should be checked after every six months of service. Filters can be cleaned but should be replaced every two years.

Compliance

• Part L1 2013 of Building Regulations for enhanced energy saving capability
• Part F 2013 of Building Regulations for reliable, efficient ventilation
• EU RoHS Directive Compliant.
• Conforms to requirements of EC Council directives relating to Electromagnetic Compatibility and Electrical Safety: 2006/95/CE(LVD), 2004/108/CE (EMC), EN 60335-2-80
• CE marked